Increasing drying efficiency by modifying the design of feed chute of the Gol-e-Gohar pelletizing plant ball mill

Increasing drying efficiency by modifying the design of feed chute of the Gol-e-Gohar pelletizing plant ball mill

  • عنوان فارسی : Increasing drying efficiency by modifying the design of feed chute of the Gol-e-Gohar pelletizing plant ball mill
  • عنوان انگلیسی : Increasing drying efficiency by modifying the design of feed chute of the Gol-e-Gohar pelletizing plant ball mill
  • مجله : Journal of Mining and Environment
  • issn(مجله) : 2251-8592
  • نوع مقاله: Journal Article
  • زبان: انگلیسی
  • نوع انتشار: مقاله چاپ شده
  • انتشار مقاله: 18-06-1397
  • شماره(No): 1
  • جایگاه : پژوهشی
  • دوره: 10
  • شماره صفحه: 213,221
  • تعداد نویسندگان: 5
  • doI: 10.22044/jme.2018.7447.1599
  • مقاله مستخرج از:
  • نویسندگان: A.R. Ghasemi , A.R. Hasankhoei , E. Razi , Gh.A. Parsapour , S. Banisi ,
  • چکیده:
  • چکیده انگلیسی: Pelletizing plant of the Gol-E-Gohar mining and industrial company consists of a burner, a dry ball mill (6.2 m × 13 m), and an air separator. The ball mill consists of a 2 m-long drying and an 11 m-long grinding chambers. The iron ore concentrate is fed to the drying chamber by a feed chute. It was found that when the feed moisture content increased from 1.3% to 3.5%, the throughput decreased by 12% (35 t/h) indicating a low performance of the dryer. Monitoring the wear rate of flights for a period of 12 months showed that the first 0.8 m (59%) length of the dryer length did not experience any wear. To overcome this problem, various feed chute designs with different geometries were simulated by the KMPCDEM© software. With the aim of arriving at a proper material trajectory, where the total length of the dryer is used, a new feed chute was selected. The simulation results indicated that if the height of the feed chute is increased from 1.60 to 2.26 m and the slope is increased from 45 to 48 degrees the material arrives at the first 0.48 m of the drying chamber. In this manner, the unused part of the drying chamber decreases from 59% to 36% of the length. After installation of the new feed chute during a period of three months, the throughput increased by 36 t/h.
Increasing drying efficiency by modifying the design of feed chute of the Gol-e-Gohar pelletizing plant ball mill

ورود

ورود به اکانت شما

@
آیا پسورد خود را فراموش کرده اید؟
ثبت نام

ثبت نام

اگر شما اکانتی ندارید همین الان اقدام کنید.

ثبت نام کنید!